登录
首页 » VHDL » 十字路

十字路

于 2022-03-04 发布 文件大小:2.61 kB
0 103
下载积分: 2 下载次数: 1

代码说明:

控制路线和街道交叉口的简单程序,路线优先,街道上有车辆检测器;

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • xge_mac_latest.tar
    Ethernet 10GE MAC 以太网10G的MAC Verilog代码实现(Ethernet 10GE MAC)
    2010-07-31 10:04:20下载
    积分:1
  • WA
    说明:  QUARTUS2 16.9 VHDL FPGA ENDAT2.2
    2020-11-24 17:50:21下载
    积分:1
  • DDS signal generator, can produce a variety of waveforms, are mysterious wave, t...
    DDS信号发生器,能产生多种波形,正玄波,三角波,方波,频率可调,相位可调-DDS signal generator, can produce a variety of waveforms, are mysterious wave, triangle wave, square wave, frequency tunable, phase adjustable
    2022-11-28 01:05:04下载
    积分:1
  • uaf42
    使用uaf42设计的有源滤波器,高通滤波器的设计参数记录(Using uaf42 design active filters, high-pass filter design parameters recorded)
    2012-09-09 21:49:49下载
    积分:1
  • -Elliptic
    We present elliptic curve cryptography (ECC) coprocessor, which is dual-field processor with projective coordinator. We have implemented architecture for scalar multiplication, which is key operation in elliptic curve cryptography. Our coprocessor can be adapted both prime field and binary field, also contains a control unit with 256 bit serial and parallel operations , which provide integrated highthroughput with low power consumptions. Our scalar multiplier architecture operation is perform base on clock rate and produce better performance in term of time and area compared to similar works. We used Verilog for programming and synthesized using Xilinx Vertex II Pro devices. Simulation was done with Modelsim XE 6.1e, VLSI simulation software from Mentor Graphics Corporation especially for Xilinx devices.
    2012-02-09 10:48:50下载
    积分:1
  • 第七次课--视频图像DCT处理及水印嵌入
    熟悉IIC协议总线协议,采用IIC总线对图像采集传感器寄存器进行配置,并转换为RGB565格式。 利用异步FIFO完成从摄像头输出端到SDRAM 和SDRAM 到VGA 接口各跨时钟域信号的传输和处理。 利用 SDRAM 接口模块的设计,实现了刷新、读写等操作;为提高SDRAM 的读写带宽,均采用突发连续读写数据方式;并采用乒乓操作实现 CMOS 摄像头与VGA的帧率匹配。 利用双线性插值方法实现对图像640×480到1024×768的放大操作。 完成VGA显示接口设计。(Familiar with IIC protocol bus protocol, IIC bus is used to configure the register of image acquisition sensor and convert it into RGB565 format. Asynchronous FIFO is used to transmit and process signals across clock domain from camera output to SDRAM and SDRAM to VGA interface. With the design of SDRAM interface module, refresh, read and write operations are realized. In order to improve the read and write bandwidth of SDRAM, burst continuous read and write data mode is adopted, and table tennis operation is used to achieve frame rate matching between CMOS camera and VGA. The bilinear interpolation method is used to enlarge the image from 640*480 to 1024*768. Complete the VGA display interface design.)
    2020-06-25 04:00:02下载
    积分:1
  • ds1302_seg7
    使用Verilog完成DS1302的驱动,工程已经经过测试,可直接使用。(DS1302 using Verilog complete drive, the project has been tested and can be used directly.)
    2014-12-10 15:27:48下载
    积分:1
  • can_init
    说明:  通过SPI接口实现FPGA和MCP2515独立CAN芯片通信,功能使用modelsim仿真,实现了配置、接收、发送功能。(The communication between FPGA and MCP2515 independent can chip is realized by SPI interface. The function is simulated by Modelsim, and the function of configuration, receiving and sending is realized.)
    2020-12-30 09:28:59下载
    积分:1
  • clock
    本程序实现数字钟系统,有整点报时功能,可显示切换年月日,定时功能(Digital clock system of this program, with the whole point timekeeping function, can display the date, the timing function)
    2015-04-19 22:07:02下载
    积分:1
  • 多个VHDL编码的例题,详细的电路图介绍,还有流程图
    多个VHDL编码的例题,详细的电路图介绍,还有流程图-many examples of VHDL code, the particular introduction of circuit diagram and flow chart
    2022-03-01 02:29:00下载
    积分:1
  • 696518资源总数
  • 105547会员总数
  • 4今日下载