-
LCD bitmap procedures, including bitmap code, and call procedures.
液晶位图程序,包括位图内码,和调用程序等等。-LCD bitmap procedures, including bitmap code, and call procedures.
- 2023-07-26 00:20:02下载
- 积分:1
-
汇编编译器
汇编编译器-Compilation of the compiler
- 2022-01-24 17:28:58下载
- 积分:1
-
C语言多种求最优的程序源代码,方便实用
对编程有很大帮助...
C语言多种求最优的程序源代码,方便实用
对编程有很大帮助-C language for a variety of optimal source code, useful for programming will be of great help
- 2022-06-28 12:27:09下载
- 积分:1
-
`
- 2022-12-10 18:05:03下载
- 积分:1
-
可驱动8/16位数码管显示或64/128只独立LED的BC8271A芯片中断方式编程代码...
可驱动8/16位数码管显示或64/128只独立LED的BC8271A芯片中断方式编程代码-can drive 8/16 Digital Display or 64/128 only independent BC8271A LED chip interrupt programming code
- 2023-07-06 21:25:02下载
- 积分:1
-
设计一种自动洗衣机的程序控制器,在启动后先进水,等到达高水位后,启动洗衣马达转动4min,如在洗衣过程中发现水位低于高水位,则停止洗衣马达转动并报警,并在水位到...
设计一种自动洗衣机的程序控制器,在启动后先进水,等到达高水位后,启动洗衣马达转动4min,如在洗衣过程中发现水位低于高水位,则停止洗衣马达转动并报警,并在水位到达高水位后再次启动马达。洗衣结束后则启动排水开关,待水位到达低水位后,则启动脱水马达,转动2min。如此重复三次,要求在每一动作之间有2s的间隔。
高水位,低水位为水位传感器,用两个开关模拟,当水位高于高水位或低于低水位时,两个开关的状态分别为0 。启动开关用一个开关表示。进水、排水、洗衣马达、脱水马达及报警分别用一个发光二极管表示。本实验只需用可编程并行接口电路的A口。其硬件接口如下图所示。也可采用可编程逻辑器件进行设计。
-Design of an automatic washing process controller, after commencement of advanced water, and so on to reach the high water mark, start laundry motor rotation 4min, such as in laundry water level lower than that found during the high water mark, then the motor stops rotating laundry and alarm, and the the water level reaches the high water mark again to start the motor. Laundry is started after the end of the drainage switch, when the water level reaches the low water level, then start the dehydration motors, rotating 2min. Repeat three times, each action requires the interval between the 2s.
High water, low water level as water level sensors, with two analog switches, when the water
- 2023-04-30 10:55:03下载
- 积分:1
-
开机时,显示12:00:00的时间开始计时;
P0.0/AD0控制“秒”的调整,每按一次加1秒;
P0.1/AD1控制“分”的调整,每按一次加1分...
开机时,显示12:00:00的时间开始计时;
P0.0/AD0控制“秒”的调整,每按一次加1秒;
P0.1/AD1控制“分”的调整,每按一次加1分;
P0.2/AD2控制“时”的调整,每按一次加1个小时;
-Boot-up, indicating the start time 12:00:00 time P0.0/AD0 control seconds of adjustment, every time plus 1 seconds P0.1/AD1 control points of adjustment, every time plus 1 points P0.2/AD2 control when adjustments, every time plus 1 hours
- 2022-04-21 03:30:24下载
- 积分:1
-
有限元模型的建立,这些程序构成了有限元模型,用PlaneFrameModel来指定...
有限元模型的建立,这些程序构成了有限元模型,用PlaneFrameModel来指定-PlaneFrameModel
- 2022-04-12 09:24:37下载
- 积分:1
-
程序用中断扫描7段数码显示,有外部中断10MS中断串行通信中断等...
程序用中断扫描7段数码显示,有外部中断10MS中断串行通信中断等-Interruption of scanning process with paragraph 7 digital display, there are external interrupt MS serial communication interruption, such as interruption
- 2022-02-07 12:07:58下载
- 积分:1
-
天龙八部3基址搜索器
天龙八部3基址搜索器 &nb
- 2022-01-22 15:22:09下载
- 积分:1