登录
首页 » VHDL » VHDL数字频率计(1)频率测量范围: 10 ~ 9999Hz 。 (2)输入电压幅度 >300mV 。 (3)输入信号波形:任意周期信号。...

VHDL数字频率计(1)频率测量范围: 10 ~ 9999Hz 。 (2)输入电压幅度 >300mV 。 (3)输入信号波形:任意周期信号。...

于 2022-07-20 发布 文件大小:252.73 kB
0 123
下载积分: 2 下载次数: 1

代码说明:

VHDL数字频率计(1)频率测量范围: 10 ~ 9999Hz 。 (2)输入电压幅度 >300mV 。 (3)输入信号波形:任意周期信号。 (4)显示位数: 4 位。 (5)电源: 220V 、 50Hz -vhdl

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 429recive
    实现FPGA接收429板卡发送的信号,并根据数据最后两位点亮相应的LED。(FPGA to achieve the 429 board to receive the signal sent, and according to the data of the last two of the corresponding LED.)
    2015-11-26 11:18:19下载
    积分:1
  • MD5
    哈希算法FPGA实现代码,采用MD5算法,并给出了仿真波形。(MD5 hashing algorithm for FPGA implementation code)
    2020-07-03 00:40:02下载
    积分:1
  • 使用vhdl实现的1024点的FFT算法
    使用vhdl实现的1024点的FFT算法-Using vhdl implementation of the 1024-point FFT algorithm
    2022-01-30 20:38:46下载
    积分:1
  • 6
    说明:  4位数码扫描显示电路,我们控制一个七段LED需要8个输出端口;如果要输出四位十进制数,就需要32的输出端口,这将占用大量的端口资源。采用串行扫描显示,我们只需要8+4共12个端口即可。其原理是:用一个四位的输出端控制,某一时刻只选中其中的一个LED(输出为‘1’表示选中),八位的输出端将该LED所需要显示的值输出;然后四位的输出端值改变,选中下一个LED。这样依次类推。如果选择的频率很快,达到50Hz以上,由于人眼的视觉暂留效应,看起来就像4个LED同时显示。 设计一个程序,输入四个一位十进制数,用4个LED显示出来。CLK采用频率可调信号发生器,逐渐改变频率,观察扫描频率的改变对输出效果的影响。 输入:连续脉冲,逻辑开关;输出:七段LED。 (4 digital scanning display circuit, we need to control a seven-segment LED output port 8 If you want to output four decimal numbers, you need the output port 32, which will take up a lot of ports. Serial scans showed, we need only 8 of 12 ports can be+4. The principle is: the output of four with a control, a time to select only one LED (output 1 is selected), 8 output of the LED by the need to show the value of the output then The output value of the four changes, select the next LED. This and so on. If you select the frequency rapidly, reaching more than 50Hz, as the human eye s persistence of vision effect, looks like a 4 LED display simultaneously. Design a program, enter a decimal number four, with four LED display. CLK signal generator with adjustable frequency, gradually changing the frequency of observed changes in scan frequency effect on the output. Input: Continuous pulse, logic switches output: seven-segment LED.)
    2010-06-21 22:07:59下载
    积分:1
  • shumagua
    通过数码管和单片机的组合 制作成的数码管时钟程序(Through the combination of digital control and made ​ ​ into a single-chip digital clock program)
    2013-10-27 12:30:04下载
    积分:1
  • bhaswatiml
    matlab code for communication
    2013-11-07 00:43:24下载
    积分:1
  • suzimiaobiao
    数字秒表的实现,我还写个具体的过程要求等,(there is function of clock,it very useful)
    2011-09-20 14:28:30下载
    积分:1
  • vhdl-cordic-atan-master
    说明:  Implementation of CORDIC atan block in VHDL
    2019-05-14 16:51:26下载
    积分:1
  • 4个7段lcd同时显示的程序,已经在digilent的nexy2板上通过验证,非常好用易懂,适合初学者学习...
    4个7段lcd同时显示的程序,已经在digilent的nexy2板上通过验证,非常好用易懂,适合初学者学习-display 4 leds
    2022-09-21 08:15:03下载
    积分:1
  • 123.rar
    請設計一個8位元移位暫存器,規格如下: 當控制線S1,S2輸入為00時,平行載入; 當控制線S1,S2輸入為01時,在一時脈內向右shift 1位元; 當控制線S1,S2輸入為10時,在一時脈內向右shift 2位元; 當控制線S1,S2輸入為11時,在一時脈內向右shift 3位元 (Serial Adder)
    2009-12-08 00:02:56下载
    积分:1
  • 696516资源总数
  • 106783会员总数
  • 25今日下载