登录
首页 » VHDL » 基于Xilinx FPGA实现PS2键盘鼠标接口。版本1.0

基于Xilinx FPGA实现PS2键盘鼠标接口。版本1.0

于 2022-07-22 发布 文件大小:16.64 kB
0 47
下载积分: 2 下载次数: 1

代码说明:

基于Xilinx FPGA实现PS2键盘鼠标接口。版本1.0-Based on Xilinx FPGA realize PS2 keyboard and mouse interface. Version 1.0

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Copy
    this file describes the steps in building a fifo buffer module in verilog hdl and programming them on an fpga device
    2020-06-21 21:00:02下载
    积分:1
  • FPGA源代码
    FPGA部分源代码,关于dsp48的应用,从一本很好的书上下的
    2023-06-23 15:05:04下载
    积分:1
  • dac
    说明:  DA芯片输出控制 SPI协议 只写不读 FPGA用 verilog(DA-chip SPI protocol output control does not read write-only FPGA with verilog)
    2011-03-16 19:04:33下载
    积分:1
  • FPGA
    说明:  基于FPGA的数字式相位测量仪的设计与制作(FPGA-Based Digital Phase Meter Design and Production)
    2010-04-16 19:40:41下载
    积分:1
  • velocity_Verilog
    速度表(velocity)要求:1.显示汽车Km/h数;2.车轮每转一圈,有一传感脉冲;每个脉冲代表1m的距离;3.采样周期设为10s; 4.要求显示到小数点后边两位;5.用数码管显示;6. 最高时速小于300Km/h。(约为83.3m/s) (use verilog to realize velocity)
    2020-07-13 15:08:51下载
    积分:1
  • mutiplier
    说明:  用VHDL语言仿真乘法器设计, 经过modelsim仿真, synplify综合,并下载进FPGA验证(Multiplier design using VHDL, simulation, after modelsim simulation, synplify synthesis, and downloaded into a FPGA verification)
    2009-08-28 13:28:04下载
    积分:1
  • bitcount
    it will count the bit
    2010-03-13 23:53:26下载
    积分:1
  • dac_spi
    DA9125 配置spi程序 正弦波产生(DA9125 configuration spi program sine wave generated)
    2017-05-27 20:17:40下载
    积分:1
  • STM32F407FFT
    使用STM32官方提供的DSP库进行FFT,虽然在使用上有些不灵活(因为它是基4的FFT,所以FFT的点数必须是4^n),但其执行效率确实非常高效,看图1所示的FFT运算效率测试数据便可见一斑。该数据来自STM32 DSP库使用文档(. Using the official DSP library provided by STM32 for FFT is not flexible in use (because it is the FFT of base 4, so the number of FFT points must be 4 ^ n), but its execution efficiency is really very efficient, as can be seen from the test data of FFT operation efficiency shown in Figure 1. This data comes from STM32 DSP library usage document)
    2020-06-20 19:00:02下载
    积分:1
  • usbd_ucos
    基于ALINX AX7020硬件平台的USB-OTG通信程序。操作系统采用uCOS III v1.41,基本实现了双向USB2.0 块传输(Bulk Transfer)通信,zynq的PS端接收USB数据并回传至主机。经测试,主机端Window10系统采用libUSBK编程时,采用64字节的块时,传输速率可达210Mbps。zynq开发工具为Vivado2015.4,程序包中包含了全部的硬件和软件工程文档。(A USB-OTG communication project where an AX7020 platform is employed as USB device. The embeded operating system is uCOS III of version 1.41, and the FPGA toolchain is Vivado 2015.4. This project implements a full speed bidirectional USB2.0 bulk transfer. A test on Windows 10 host with libUSBK shows that the transfer speed is up to 201Mbps.)
    2020-09-09 09:38:02下载
    积分:1
  • 696524资源总数
  • 103791会员总数
  • 67今日下载