登录
首页 » 嵌入式系统 » 通过键盘设定温度和加热时间。 (2)使用DS18B20采集温度,采用七段数码管显示当前温度和剩余时间,并和设置的温度进行比较。 (3)当温度低于设定值时...

通过键盘设定温度和加热时间。 (2)使用DS18B20采集温度,采用七段数码管显示当前温度和剩余时间,并和设置的温度进行比较。 (3)当温度低于设定值时...

于 2022-09-26 发布 文件大小:271.94 kB
0 143
下载积分: 2 下载次数: 1

代码说明:

通过键盘设定温度和加热时间。 (2)使用DS18B20采集温度,采用七段数码管显示当前温度和剩余时间,并和设置的温度进行比较。 (3)当温度低于设定值时,通过DAC0832输出电压供给发热电阻RT1,使其温度升高。 -Through the keyboard setting temperature and heating time. (2) The use of DS18B20 collecting temperature, using seven-segment digital tube displays the current temperature and the remaining time, and and set the temperature for comparison. (3) When the temperature is below the set value, the DAC0832 output voltage of the supply of heat through the resistor RT1, so that temperature.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • dspic30f列的CAN总线设置以及收发程序源码
    应用背景时下比较流行的一种安全可靠的总线通讯方式,CAN通讯在dspic30f单片机的实线过程,源码。已经经过实际项目的检验觉得ok关键技术CAN应用场合非常多,比如机器人控制器开发、以及汽车传感器技术检测以及通讯以及工业数控机床的实时通讯等相关领域都得到广泛应用。
    2022-09-30 18:00:03下载
    积分:1
  • 红外遥控器已被广泛使用在各种类型的家电产品上,它的出现给使用家器提供了很多的便利。红外遥控一般由红外发射装置和红外接受设备两大部分组成。红外发射装置又可由键...
    红外遥控器已被广泛使用在各种类型的家电产品上,它的出现给使用家器提供了很多的便利。红外遥控系统一般由红外发射装置和红外接受设备两大部分组成。红外发射装置又可由键盘电路、红外编码芯片、电源和红外发射电路组成。红外接收设备可由红外接收电路、红外解码芯片、电源和应用电路组成。通常为了使信号能更好的被传输发送端将基带二进制信号调制为脉冲串信号,通过红外发射管发射。本设计采用Atmega8作为红外发射编码和接收解码芯片。-Infrared remote control has been widely used in various types of household electrical appliances, it" s there to provide the users a lot of convenience. Infrared remote control system in general by the infrared emission devices and infrared devices to accept the composition of two major parts. Infrared emission circuit device can be by keyboard, infrared encoder chip, power and infrared emission circuit. By the infrared receiver infrared receiver circuit equipment, infrared decoder chip, power supply and application circuit. Usually better in order to signal the sending end of the transmission to binary base-band signal for pulse modulation, through the launch tube infrared emission. The design uses infrared emission Atmega8 as encoding and decoding chip receiver.
    2022-05-06 14:11:23下载
    积分:1
  • 太阳能机械跟踪扫描方法
    该项目包括对 ldr 和 2 步进电机和微泰文 16 2 uln2003 面包板1-它扫描所有周围和所有的光照强度的措施2 它指定的最大的光照强度及其值3 — — 它旋转,停靠的最大值的位置4 — — 它能做的一切这 2 轴 x 与 y 中的步骤,并且停止在光的最大值5 — — 它的措施的光照强度不断和重复循环如果光照强度下降比 0.8 * m
    2022-01-25 17:34:39下载
    积分:1
  • 54x54
    54x54-bit Radix-4 Multiplier based on Modified Booth Algorithm
    2023-06-01 23:10:03下载
    积分:1
  • 一个垃圾压缩车的PLC程序。采用X端口作为模拟量转换后的数据量输口。这种方法不需要买模拟量模块,1000块就省下来了!...
    一个垃圾压缩车的PLC程序。采用X端口作为模拟量转换后的数据量输入口。这种方法不需要买模拟量模块,1000块就省下来了!-A garbage truck PLC compression procedures. X-port analog conversion, as the amount of data input. This method does not need to buy analog module 1000 on the savings!
    2023-08-24 17:05:07下载
    积分:1
  • 44b0(arm)初始化程序,代码可以通用,方便的开发
    44b0(arm)初始化程序,代码可以通用,方便嵌入式系统的开发-44b0 (arm) initialization procedure, the code can be generic to facilitate the development of embedded systems
    2023-08-25 13:25:03下载
    积分:1
  • 一个USB键盘的驱动程序,调试了很久已通过,相信对大家有帮助!...
    一个USB键盘的驱动程序,调试了很久已通过,相信对大家有帮助!-A USB keyboard drivers, debugging for a long time has passed, I believe everyone has to help!
    2022-02-13 14:13:09下载
    积分:1
  • A small embedded TCP/IP protocol stack running in a 16bits data signal processor...
    实现一个运行在16位数字信号处理器TMS320VC5402上的小型嵌入式TCP/IP协议栈。对TCP/IP协议中的IP协议、ARP协议、UDP协议进行分析,完成基于TCP/IP协议的嵌入式网络系统-A small embedded TCP/IP protocol stack running in a 16bits data signal processor TMS320VC5402 is implemented. IP, ARP, UDP etc. protocols in TCP/IP protocol stack are analyzed. A embeded network system based on TCP/IP is completed.
    2023-03-04 21:50:03下载
    积分:1
  • embedded operating system compiler environment hardware structure transplant...
    μC/OS-Ⅱ是一个完整的,可移植、固化和裁剪的实时多任务内核,是用ANSI的C语言编写的,包含一小部分汇编语言代码,使之可供不同架构的微处理器使用。-embedded operating system compiler environment hardware structure transplantation Case
    2023-05-21 12:30:04下载
    积分:1
  • ISE 9.2列工作
    ISE 9.2 serials working
    2022-07-16 22:16:12下载
    积分:1
  • 696518资源总数
  • 106164会员总数
  • 18今日下载