-
24c16 收发程序 8051单片机
24c16 收发程序 8051单片机-24c16 transceiver procedures 8051
- 2022-09-28 13:45:03下载
- 积分：1
-
本系统参照片上系统的设计架构、采用FPGA与SPCE061A相结合的方法，以SPCE061A单片机为进程控制和任务调度核心；FPGA做为外围扩展，内部自建系统总...
本系统参照片上系统的设计架构、采用FPGA与SPCE061A相结合的方法，以SPCE061A单片机为进程控制和任务调度核心；FPGA做为外围扩展，内部自建系统总线，地址译码采用全译码方式。FPGA内部建有DDS控制器，单片机通过系统总线向规定的存储单元中送入正弦表；然后DDS控制器以设定的频率，自动循环扫描，生成高精度，高稳定的5Hz基准测量信号。-The system with reference to the design of system-on-chip architecture, used a combination of FPGA and SPCE061A approach to SPCE061A Singlechip for process control and scheduling core mission FPGA for external expansion, internal self-system bus, address decoding using the entire translated code approach. DDS has built internal FPGA controller, microcontroller through the system bus to the provisions of the storage unit into the sine table DDS controller and then to set the frequency, automatic cycle of scanning, to generate high precision and high stability of the baseline measurement 5Hz signal.
- 2023-06-10 08:35:03下载
- 积分：1
-
红外线遥控解码器,该程序实现将红外遥控器发出的红外线解码，并通过LCD显示出来...
红外线遥控解码器,该程序实现将红外遥控器发出的红外线解码，并通过LCD显示出来 -infrared remote control decoder, the program will infrared remote control and using the infrared decoding, and out through the LCD display
- 2022-12-27 20:15:04下载
- 积分：1
-
设计程序使一个LED发光管以0.6秒为周期闪烁，即发光管每0.3秒点亮或熄灭一次。
分析题目要求，主要涉及两方面的操作，即控制LED发光管的亮灭以及定时0....
设计程序使一个LED发光管以0.6秒为周期闪烁，即发光管每0.3秒点亮或熄灭一次。
分析题目要求，主要涉及两方面的操作，即控制LED发光管的亮灭以及定时0.3秒。对于LED发光管，只用一个IO就可以控制了（例如使用IOA0）；而对于0.3秒定时，我们可以利用TimerA定时器轻易地实现。-The design process of a LED to LED blinking 0.6 seconds for the cycle, that is, every 0.3 seconds LED lit or extinguished once. Analysis of the subject requirements, mainly related to two aspects of the operation, that is, control LED LED light out as well as the timing of 0.3 seconds. The LED light-emitting tube, only one can control the IO (such as the use of IOA0) and for 0.3 seconds from time to time, we can use to easily achieve TimerA timer.
- 2022-03-16 15:40:25下载
- 积分：1
-
keil下的s3c44b0驱动LCD伪彩屏例子程序。
keil下的s3c44b0驱动LCD伪彩屏例子程序。-keil under the pseudo-color LCD driven S3C44B0 example of the procedure.
- 2022-02-09 13:39:29下载
- 积分：1
-
PIC16F877控制LED进行任何显示，该源码只做了北京两个字的显示...
PIC16F877控制LED进行任何显示，该源码只做了北京两个字的显示-PIC16F877 to control LED of any revealed that the source only the word display in Beijing
- 2022-07-23 14:16:00下载
- 积分：1
-
这是一个广告转换器，它使多
这是一个AD转换程序,可实现多路AD转换,其运行是基于凌阳的spc061A单片机-This is an AD converter, which enables multi-channel AD converter. its operation is based on SCM Sunplus the spc061A
- 2023-01-06 22:45:03下载
- 积分：1
-
该方案要求利用凌阳科技，公司SPLC501A液晶模块…
本方案要求利用凌阳科技公司的SPLC501A液晶模组作为显示模块，凌阳16位单片机SPCE061A
作为主控芯片，充分利用SPCE061A精简开发板（简称61板）上面的三个按键，完成一个简易的数
字系统――数字电子钟。
-The program requires the use of Sunplus Technology, Inc. SPLC501A LCD module as the display module, Sunplus 16-bit single-chip microcomputer as the master chip SPCE061A make full use of SPCE061A streamline development board (hereinafter referred to 61 plates) above the three buttons to complete a simple of digital systems- digital electronic clock.
- 2022-08-31 20:20:03下载
- 积分：1
-
直流电机转速控制，通过按键来选择显示速度…
直流电机速度控制 可通过按键来选择转速在LED上显示 使用的是C8051F 单片机-DC motor speed control through the keypad to select the speed in the LED display using a single-chip microcomputer C8051F
- 2022-02-05 18:20:36下载
- 积分：1
-
LCD驱动AVR。基于ATmega 16测试。
LCD Driver to AVR. Tested on ATMEGA 16.
- 2023-06-10 16:45:02下载
- 积分：1
