-
Plot-Of-CUMCM2011A
2011数学建模A题第一问的matlab源程序(2011 A mathematical modeling of the first questions to ask matlab source)
- 2011-09-11 19:06:42下载
- 积分：1
-
Substation-panel-electrical-parameters-computatio
Substation panel electrical parameters comptation
- 2014-02-04 20:28:33下载
- 积分：1
-
OL_CLMIMOcapacity
开环闭环对比的MIMO信道容量，附公式推导的word文档，对物理层安全理论推导有一定借鉴意义(Comparison of open loop closed loop MIMO channel capacity, word documents attached derivation of the theoretical derivation of the physical layer security will provide experience)
- 2015-05-06 21:00:48下载
- 积分：1
-
999999
实现马尔科夫的语音识别功能 可以实现连续语音识别，孤立词识别(Of Markov s voice recognition capabilities can achieve continuous speech recognition, isolated word recognition)
- 2012-03-21 19:50:12下载
- 积分：1
-
MATLAB
matlab内容精讲，自己看过了感觉挺好的
推荐学习matlab的同学们可以看看(The matlab content succinctly and have seen a very good feeling the recommended learning matlab classmates can look)
- 2012-09-10 19:39:02下载
- 积分：1
-
niiicode
number of blobs detection in rbc images
- 2015-03-14 23:13:00下载
- 积分：1
-
CUT_DETECTION
Cut detection algorithm, uses histogram comparisonmethod.I ve also added a set of images.
- 2010-01-21 20:56:38下载
- 积分：1
-
Link-a-System-Level-OFDM-Simulator
针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator.
Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.
System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.
Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection.
System-level simulator, currently support only SISO and 1 by 2 MRC.
To start with, go into the folder sys_link_simu, and excute the following commond from matlab:
sys_link_simu_func(a,b)
where a is the link ada)
- 2011-08-09 11:00:53下载
- 积分：1
-
Track-Association-with-PDA
采用PDA算法实现量测-航迹关联，常用于目标跟踪(track association with PDA)
- 2021-03-23 15:29:15下载
- 积分：1
-
romp
说明： 压缩感知代码,在matlab编程环境中实现。代码结构清晰易懂。(code of compression perception)
- 2011-03-04 10:59:34下载
- 积分：1
