-
基于阵型的误差分析
对等边直角三角形阵和立体三棱锥阵进行仿真建模，并进行了定向定位的误差分析，得到了相应的波形。(The simulation modeling of the equilateral triangle array and the stereoscopic three pyramid array is carried out, and the error analysis of directional positioning is carried out, and the corresponding waveforms are obtained.)
- 2017-12-05 11:34:47下载
- 积分：1
-
usermat_CDM
说明： These composite materials generally exhibit brittle damage behavior. The anisotropy in the
material and different kinds of failure mechanisms make it difficult to accurately
characterize the behavior of composite materials. The present work aims to verify and
apply the Puck Failure Criteria using the commercially available finite element package
ANSYS by writing a user-material subroutine in FORTRAN. The model is implemented
with different post failure degradation schemes EWM/CSE.
- 2019-05-01 00:48:50下载
- 积分：1
-
二+三+四自由度模型
说明： 车辆二自由度（三种方式），三自由度，四自由度车辆模型，参数齐全，可完美运行，绝不忽悠！(Vehicle two degrees of freedom (three ways), three degrees of freedom, four degrees of freedom vehicle model, complete parameters, perfect operation, never fooling!)
- 2020-01-07 09:44:45下载
- 积分：1
-
buckling
说明： 薄壁圆柱壳轴压屈曲非线性计算，采用模态缺陷作为初始缺陷(In the nonlinear calculation of thin-walled cylindrical shells under axial compression, modal defects are used as initial defects)
- 2020-06-29 15:34:17下载
- 积分：1
-
parking
说明： 利用MATLAB实现平行泊车过程演示，实现泊车动画演示。(MATLAB parallel parking process demonstration.)
- 2020-06-10 15:23:55下载
- 积分：1
-
滞环电流控制
三相永磁同步电机的滞环电流控制仿真模型，控制瞬态电流输出。(Simulation Model of hysteresis current Control for Three-phase permanent Magnet synchronous Motor)
- 2020-10-26 12:00:00下载
- 积分：1
-
FuzzyMath.m
说明： 自己编写的，利用模糊数学方法计算船舶碰撞危险度得matlab程序(Self-compiled matlab program for calculating ship collision risk using fuzzy mathematics method)
- 2021-02-27 14:19:36下载
- 积分：1
-
1
说明： 基于信噪比的协作频谱感知算法，能量检测。信噪比(Collaborative Spectrum Sensing Algorithm Based on Signal - to - Noise Ratio.Energy detection.Signal - to - Noise Ratio.)
- 2017-07-24 10:21:00下载
- 积分：1
-
Random_Waypoint
实现了random waypoint模型(random waypoint model)
- 2017-06-20 11:21:12下载
- 积分：1
-
瞬态动力学分析
三个ANSYS瞬态分析的命令流：冲击载荷作用悬臂梁的阻尼振动分析；破碎锤的瞬态动力学分析；滑动摩擦接触分析(Three command streams of ANSYS transient analysis: damped vibration analysis of cantilever beam under impact load; transient dynamic analysis of crushing hammer; sliding friction contact analysis)
- 2020-06-16 19:20:01下载
- 积分：1
