-
单片机温度控制
12864显示 温度 湿度控制 继电器 上位机 vb6编程 知道控制
- 2022-07-02 14:10:11下载
- 积分：1
-
针对传统电液比例控制系统的性能较差，本文提出了一种基于ARM和uC/OS...
针对传统电液比例控制系统的性能较差，本文提出了一种基于ARM和uC/OS-II的电液比例控制系统的设计，并详细介绍了以ARM内核微控制器LPC2292和电机驱动芯片LMD18200为核心的硬件电路，以及嵌入式操作系统μC/OS-II在ARM7上的实现。-Traditional electro-hydraulic proportional control system for poor performance, this paper presents an approach based on ARM and uC/OS-II of the electro-hydraulic proportional control system design and described in detail in order to ARM core LPC2292 microcontroller and motor driver chip LMD18200 at the core of the hardware circuit, as well as the embedded operating system μC/OS-II in the realization of ARM7.
- 2022-01-21 22:09:39下载
- 积分：1
-
AT91M40800源码，包含串口，液晶屏，按键等
AT91M40800源码，包含串口，液晶屏，按键等-AT91M40800 source, including the serial port, LCD screen, buttons, etc.
- 2022-03-14 03:48:39下载
- 积分：1
-
ARM键盘，LCD驱动程序
ARM键盘，LCD驱动程序-ARM keyboard, LCD Driver
- 2022-03-07 09:17:18下载
- 积分：1
-
ZLG SmartARM2300 of the factory demo program, including the board of all drivers...
ZLG SmartARM2300的出厂演示程序，包含板子上的所有驱动程序，基于ADS+uCos-ZLG SmartARM2300 of the factory demo program, including the board of all drivers, based on ADS+ UCos
- 2023-03-09 18:55:02下载
- 积分：1
-
sdconfig.h: The document for the SD card reader module configuration header file...
sdconfig.h: 该文件为SD卡读写模块配置头文件，用户可根据实际硬件条件进行修改.
SD目录 : SD卡读写模块的全部文件,一般不用修改.
建议sdconfig.h文件不要放于SD目录中，因为SD目录中的文件一般无须修改,而sdconfig.h通常会有改动.
-sdconfig.h: The document for the SD card reader module configuration header files, the user hardware according to actual conditions can be modified. SD directory: SD card reader module all the documents, the general need not be amended. sdconfig.h document recommends not to put in SD directory, because the SD files in the directory are not normally required to be amended and the changes are usually sdconfig.h.
- 2022-03-12 03:53:48下载
- 积分：1
-
Schematic SEED
SEED-F2812原理图,几乎包括了F2812的所有典型应用-Schematic SEED-F2812, F2812 nearly all the typical application
- 2023-03-05 21:20:04下载
- 积分：1
-
读取EASYARM2200教学实验平台上的P0.14口上的电平值，然后将值输出控制蜂鸣器...
读取EASYARM2200教学实验平台上的P0.14口上的电平值，然后将值输出控制蜂鸣器-Read EASYARM2200 teaching experiment platform P0.14 mouth on the level value, and then the value of output control buzzer
- 2022-05-07 13:46:50下载
- 积分：1
-
这是一个实现向一块ARM板上移植uclinux2.0的程序,通过PC机的串口1可实现向目标板的flash里面写入uclinux2.0...
这是一个实现向一块ARM板上移植uclinux2.0的程序,通过PC机的串口1可实现向目标板的flash里面写入uclinux2.0- This is a realization transplants uclinux2.0 together to the
ARM board on the procedure, 1 may realize through the PC machine
string mouth to inside goal board flash reads in uclinux2.0
- 2022-11-24 16:45:03下载
- 积分：1
-
arm7t powerpcb file
arm7t powerpcb file
- 2022-04-07 20:22:51下载
- 积分：1
