-
LaurentCPM
Laurent程序,用于CPM信号的调制,接收和分解,译码,以及判断(Laurent procedures for CPM modulation of the signal, and decomposition receiving, decoding, and to determine)
- 2013-08-16 01:32:40下载
- 积分：1
-
truck_lights
Lights, Car light emulator for turn, stop and emergency
- 2012-11-06 18:27:06下载
- 积分：1
-
本代码介绍了使用VHDL开发FPGA的一般流程，最终采用了一种基于FPGA的数字频率的实现方法。该设计采用硬件描述语言VHDL，在软件开发平台ISE上完成，可以...
本代码介绍了使用VHDL开发FPGA的一般流程，最终采用了一种基于FPGA的数字频率的实现方法。该设计采用硬件描述语言VHDL，在软件开发平台ISE上完成，可以在较高速时钟频率（100MHz）下正常工作。该设计的频率计能准确的测量频率在1Hz到100MHz之间的信号。使用ModelSim仿真软件对VHDL程序做了仿真，并完成了综合布局布线，最终下载到芯片Spartan-II上取得良好测试效果。-the code on the FPGA using VHDL development of the general process, finally adopted a FPGA-based digital frequency method. The design using VHDL hardware description language, the software development platform ISE completed, the higher speed clock frequency (100MHz) under normal work. The design of the frequency meter can be accurately measured in a frequency of 100MHz between Hz signal. Use ModelSim VHDL simulation software to do the simulation process, and completed a comprehensive layout cabling, downloaded to the final chip Spartan-II made good on the test results.
- 2022-10-09 05:15:03下载
- 积分：1
-
xilinx 开发板原程序，双口RAM控制
xilinx 开发板原程序，双口RAM控制-Xilinx development board the original procedures, dual-port RAM control
- 2022-07-26 06:17:10下载
- 积分：1
-
VHDL描述的时钟分频电路，用途广
VHDL描述的时钟分频电路，用途广-VHDL description of the clock divider circuit, uses widely ...
- 2022-03-10 15:35:57下载
- 积分：1
-
SourceFile
PS2键盘实验Verilog HDL代码(PS2 keyboard experiment Verilog HDL code)
- 2008-03-15 01:14:55下载
- 积分：1
-
FIRDF_design
FIR带通、带阻滤波器设计，需要输入截止频率以及容许偏差。(FIR band pass and band stop filter design)
- 2020-09-28 15:17:44下载
- 积分：1
-
在SOPC Builder的UART IP核接口
UART RS232 IPCORE for sopc builder
-RS232 UART IPCORE for sopc builder
- 2022-03-04 13:15:40下载
- 积分：1
-
CORDIC算法的硬件实现 用的verilog语言
CORDIC算法的硬件实现 用的verilog语言-CORDIC algorithm Hardware Implementation of the Verilog language
- 2022-02-01 05:03:35下载
- 积分：1
-
usbd_ucos
基于ALINX AX7020硬件平台的USB-OTG通信程序。操作系统采用uCOS III v1.41，基本实现了双向USB2.0 块传输（Bulk Transfer）通信，zynq的PS端接收USB数据并回传至主机。经测试，主机端Window10系统采用libUSBK编程时，采用64字节的块时，传输速率可达210Mbps。zynq开发工具为Vivado2015.4，程序包中包含了全部的硬件和软件工程文档。(A USB-OTG communication project where an AX7020 platform is employed as USB device. The embeded operating system is uCOS III of version 1.41, and the FPGA toolchain is Vivado 2015.4. This project implements a full speed bidirectional USB2.0 bulk transfer. A test on Windows 10 host with libUSBK shows that the transfer speed is up to 201Mbps.)
- 2020-09-09 09:38:02下载
- 积分：1
