-
practical_lift_controller
实用电梯控制器
实用电梯控制系统block symbol file
实用电梯控制器的Verilo
practical_lift_controller
实用电梯控制器
实用电梯控制系统block symbol file
实用电梯控制器的Verilog HDL程设计-practical utility practical_lift_controller elevator controller elevator control system block symbol file utility elevator controller Verilog HDL-way design
- 2023-03-27 22:00:04下载
- 积分：1
-
gobang
一个用verilog实现的五子棋程序，用在fpga上，连接显示器，可选择与电脑对战或是双人对战，按wsad控制方向，回车控制落子，程序会自动判断输赢并显示结果(A 331 procedures implemented by verilog, used in fpga, connect the monitor, you can choose to play against the computer or a double play, press wsad control the direction, carriage control Lazi, the program will automatically determine the winners and losers and display the results)
- 2015-03-30 13:13:35下载
- 积分：1
-
This application note explains the process of eveloping and debugging a hardware...
This application note explains the process of eveloping and debugging a hardware abstraction layer (HAL) software device driver, to aid device driver development for the HAL of the Altera Nios® II system. The various software development stages are illustrated using the Altera_Avalon_UART as an example hardware device, and an example of a HAL software device driver called my_uart.-This application note explains the process of eveloping and debugging a hardware abstraction layer (HAL) software device driver, to aid device driver development for the HAL of the Altera Nios® II system. The various software development stages are illustrated using the Altera_Avalon_UART as an example hardware device, and an example of a HAL software device driver called my_uart.
- 2022-01-23 11:16:04下载
- 积分：1
-
can总线
说明： SJA1000的ip核和相关测试脚本,OPENCORES 下载(SJA1000 IP downloads from opencores)
- 2019-11-15 10:07:14下载
- 积分：1
-
eda
EDA 正弦信号发生器：正弦信号发生器的结构有四部分组成，如图1所示。20MHZ经锁相环PLL20输出一路倍频的32MHZ片内时钟,16位计数器或分频器CNT6，6位计数器或地址发生器CN6，正弦波数据存储器data_rom。另外还需D/A0832（图中未画出）将数字信号转化为模拟信号。此设计中利用锁相环PLL20输入频率为20MHZ的时钟，输出一路分频的频率为32MHZ的片内时钟，与直接来自外部的时钟相比，这种片内时钟可以减少时钟延时和时钟变形，以减少片外干扰 还可以改善时钟的建立时间和保持时间，是系统稳定工作的保证。CNT6用来将32MHZ进行8分频得到4096HZ的频率提供给CN6与data_rom时钟信号。由CLK端输入20MHZ的时钟信号，在DOUT端就可输出稳定的正弦信号。(Sine signal generator has the structure of four parts, as shown in figure 1 below. The 20 MHZ phase lock loop PLL20 output all the way of frequency doubled within 32 MHZ slice clock, 16 counter or prescaler CNT6, six counter or address generator CN6, sine data storage data_rom. In addition to D/A0832 (shown in not draw) will digital signal into analog signals. This design using the phase lock loop PLL20 input frequency for 20 MHZ clock, the output of the frequency of all points frequency of 32 pieces (MHZ clock, and comes directly from the external clock, compared to this piece of clock can reduce the clock in delay and clock deformation, to reduce the interference of Can also improve the establishment of the clock time and keep time, is the system stability of assurance. CNT6 used to will and to 8 MHZ get 4096 HZ dividing the frequency to provide CN6 and data_rom clock signal. The input by CLK 20 MHZ clock signal, in DOUT end can output stable sine signals.
)
- 2021-03-07 15:49:29下载
- 积分：1
-
DE2_NIOSII_uCOSII_2012
一个简单的UCOSII操作系统，在DE2上面调试通过(A simple UCOSII operating systems, debugging through the DE2 above)
- 2012-08-20 10:48:08下载
- 积分：1
-
完成一个FIR数字滤波器的设计。要求：
1、 基于直接型和分布式两种算法。
2、 输入数据宽度为8位，输出数据宽度为16位。
3、 滤波器的阶数为1...
完成一个FIR数字滤波器的设计。要求：
1、 基于直接型和分布式两种算法。
2、 输入数据宽度为8位，输出数据宽度为16位。
3、 滤波器的阶数为16阶，抽头系数分别为h[0]=h[15]=0000，h[1]=h[14]=0065，h[2]=h[13]=018F，h[3]=h[12]=035A，h[4]=h[11]=0579，h[5]=h[10]=078E，h[6]=h[9]=0935，h[7]=h[8]=0A1F。
-Completion of a FIR digital filter design. Requirements: one, based on the direct type and distributed two algorithms. 2, input data width of 8, the output data width of 16. 3, filter order of 16 bands, tap coefficients for h [0] = h [15] = 0000, h [1] = h [14] = 0065, h [2] = h [13] = 018F , h [3] = h [12] = 035A, h [4] = h [11] = 0579, h [5] = h [10] = 078E, h [6] = h [9] = 0935, h [7] = h [8] = 0A1F.
- 2022-10-24 20:10:03下载
- 积分：1
-
test bench for alu 6 functions
test bench for alu 6 functions
- 2022-03-02 06:50:51下载
- 积分：1
-
基于Verilog的PCI总线接口的设计及应用
基于Verilog的PCI总线接口的设计及应用-Verilog-based PCI-bus interface design and application.
- 2023-01-05 03:35:06下载
- 积分：1
-
alu
说明： 用Verilog编写的简单的运算单元（ALU），可实现加、减、与、或、异或、非、左、右移等功能(Verilog prepared with simple arithmetic unit (ALU), can be add, subtract, and, or, exclusive-OR, non-, left, and other functions shifted to right)
- 2009-07-28 16:20:52下载
- 积分：1
