登录
首页 » VHDL » 一个基于FPGA的数字跑表系统的设计,最小单位是百分表位。采用十进制进位。...

一个基于FPGA的数字跑表系统的设计,最小单位是百分表位。采用十进制进位。...

于 2023-06-07 发布 文件大小:42.83 kB
0 19
下载积分: 2 下载次数: 1

代码说明:

一个基于FPGA的数字跑表系统的设计,最小单位是百分表位。采用十进制进位。-FPGA-based digital stopwatch system design, the smallest unit is a digital dial indicator. Binary using the metric system.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 文本液晶屏上显示计数器
    这是一个项目,设计一个计数器和 vhdl 语言文本液晶屏上显示。为了文本液晶屏上显示我们都用 vhdl 语言设计了液晶显示控制器。
    2022-03-15 04:31:20下载
    积分:1
  • WB_I2C
    Routine for I2C in VHDL
    2009-03-21 03:32:58下载
    积分:1
  • fsk
    基于FPGA的fsk调制程序,包括载波的生成,nco的设置(FPGA-based fsk modulation procedures, including carrier generation, nco settings)
    2016-05-12 21:00:56下载
    积分:1
  • TSL1401_CCD_Test
    十分基础的CCD的测试程序,大家可以下载调试CCD(this is a ccd test chengxu ,it is very good to use ,you can down it )
    2016-03-14 16:50:18下载
    积分:1
  • 29_ad9226_test
    用Verilog编写ad_9866的相应程序,在FPGA上实现相应功能(The corresponding program of ad_9866 is written with Verilog, and the corresponding functions are realized on the FPGA.)
    2019-06-24 16:43:27下载
    积分:1
  • codings
    wavelet transform of a signal,it is important and useful code to trans form frequency to time domain
    2013-11-10 15:10:32下载
    积分:1
  • subway-ticket-vending-system
    本设计是基于FPGA设计一个地铁自动售票系统。 本设计采用自顶向下的模块化设计方法,基于FPGA使用VHDL语言设计制作一个地铁自动售票控制系统,该系统能出售2条线路3种不同价位的票,完成售票、找零、显示等功能。(The design is based FPGA design of a subway ticket vending system. This design uses a top-down, modular design method, a subway ticket vending control system based on FPGA using VHDL language design, the system can sell two lines of different priced tickets, complete the ticket, give change, display and other functions .)
    2013-02-27 12:59:49下载
    积分:1
  • fir
    vhdl code for fir filter
    2011-02-18 11:51:26下载
    积分:1
  • HDMI接口编解码传输模块ASIC设计_刘文杰
    说明:  ? 熟悉IIC协议总线协议,采用IIC总线对图像采集传感器寄存器进行配置,并转换为RGB565格式。 ? 利用异步FIFO完成从摄像头输出端到SDRAM 和SDRAM 到VGA 接口各跨时钟域信号的传输和处理。 ? 利用 SDRAM 接口模块的设计,实现了刷新、读写等操作;为提高SDRAM 的读写带宽,均采用突发连续读写数据方式;并采用乒乓操作实现 CMOS 摄像头与VGA的帧率匹配。 ? 利用双线性插值方法实现对图像640×480到1024×768的放大操作。 ? 完成VGA显示接口设计。(Familiar with IIC protocol bus protocol, IIC bus is used to configure the register of image acquisition sensor and convert it into RGB565 format. Asynchronous FIFO is used to transmit and process signals across clock domain from camera output to SDRAM and SDRAM to VGA interface. With the design of SDRAM interface module, refresh, read and write operations are realized. In order to improve the read and write bandwidth of SDRAM, burst continuous read and write data mode is adopted, and table tennis operation is used to achieve frame rate matching between CMOS camera and VGA. The bilinear interpolation method is used to enlarge the image from 640*480 to 1024*768. Complete the VGA display interface design.)
    2020-06-25 04:00:02下载
    积分:1
  • fft
    说明:  fft代码,采用蝶形算法,包括C,matlab和verilog代码(fft code, using butterfly algorithm, including C, matlab and Verilog code)
    2008-11-29 11:09:47下载
    积分:1
  • 696524资源总数
  • 103920会员总数
  • 65今日下载